www.fmiproducts.com
121082-01K
13
INSTALLATION
Continued
INSTALLING FIREBOX USING
OPTIONAL ACCESSORY MANTELS
WARNING: A qualied service
person must install rebox. Fol-
low all local codes.
This rebox may be installed using the corner
or cabinet mantel with hearth base acces-
sories against a wall in your home. A trim
kit is included with mantel accessories (see
Accessories, page 31).
1. Assemble cabinet mantel, hearth base,
and trim accessories. Assembly instruc-
tions are included with each accessory.
2.
Install gas piping to rebox location. See
Installing Gas Piping to Fireplace Location.
You may have to cut a hole in the oor or
wall to run gas line to rebox. Make sure
to locate access hole so it is covered by
mantel/base when installed.
3.
Place hearth base against wall at installation
location. Cut an access hole in hearth top to
run exible gas line to rebox (see Figure 11).
Make sure to locate access hole so cabinet
mantel will cover it when installed.
Note: You can secure base to oor using
wood screws. Countersink screw heads
and putty over.
4. Route exible gas line through access
hole in hearth base.
5.
Center cabinet mantel on hearth base
(see Figure 12). Make sure mantel is ush
against wall.
6. Install trim kit furnished with mantel. See
instruction sheet included with mantel.
7. Carefully insert rebox into cabinet mantel.
Be careful not to scratch rebox, mantel,
base, etc. when installing (see Figure 13).
Figure 12 - Center Mantel on Hearth Base
INSTALLING GAS PIPING TO
FIREPLACE LOCATION
WARNING: This appliance
requires a 1/2" NPT (National
Pipe Thread) inlet connection to
the pressure regulator.
WARNING: A qualied service
person must connect replace
to gas supply. Follow all local
codes.
CAUTION: Never connect pro-
pane/LP replace directly to the
propane/LP supply. This replace
requires an external regulator
(not supplied). Install the external
regulator between the replace
and propane/LP supply.
Mantel
Figure 11 - Placing Hearth Base
Accessory Against Wall
Hearth
Base
Gas Line
Access Hole
Rigid Pipe and
Gas Shutoff
Valve
Figure 13 - Inserting Firebox Into
Cabinet Mantel (Model May Vary From
Illustration)
Hearth
Base