www.fmiproducts.com
113084-01L10
INSTALLATION
Continued
CAUTION: Do not remove the
-
INSTALLING GAS LOG INTO STOVE
1. Remove log from carton.
2. Remove all protective packaging applied
to log for shipment.
3. Check log for any shipping damage. If
damaged (pieces larger than the size of a
dime), promptly inform dealer where you
bought heater.
4. Set one-piece log on heater base as
shown in Figure 6. Make sure middle
section at bottom of log is seated into “U”
shaped cutout in center of heater base.
Log will t securely on base. IMPORTANT:
Make sure log does not cover any burner
ports and does not touch the stove cavity
(see Figure 7).
5. Fasten back panel to stove with four M6
x 1 bolts and washers.
6. Place freestanding stove in desired posi-
tion in room. Be sure to maintain clear-
ances to combustibles as outlined on
page 8.
CAUTION: After installa-
With the heater set to HI, check
-
Burner Porting Areas (double
slotted rectangular openings)
Figure 7 - Top View of One-Piece Log Set
on Gas Log Heater
Safety Pilot Location
One-Piece
Log Set
One-Piece
Log Set
“U” Shaped
Cutout in Chassis
Burner
Middle
Section at
Bottom of
Log Set
Figure 6 - Installing One-Piece Stove Log
Set
Heater Base
CONNECTING TO GAS SUPPLY
CAUTION: Never connect
-