Filter
Top Products
How to Use Con’t
JET VACUUM
Position 3 - Jet Vacuum Mode This position is intended to be used
to collect debris which is damp or stubborn. It directs a small jet of
air towards the ground which will loosen stubborn material.
Using As A Jet Vacuum
1. Select position 3 on the mode indicator. See fig N.
2. Position the nozzle above and slightly forward of the debris and
squeeze the trigger.
3. Slowly move the nozzle back over the debris. This allows a jet of air to
lift the debris from the ground.
4. To stop release the trigger.
P
✔
✕
Emptying your Gardenvac
• Switch off and disconnect from the mains
electricity supply BEFORE REMOVING OR
REPLACING the fully assembled debris bag.
Emptying Your Gardenvac
1. Remove debris bag as described on page 4.
2. Empty debris bag holding the moulded handle at
the top of the bag and the fabric handle at the
bottom of the bag. (P)
D
O
N
OT
P
LACE
H
ANDS IN
B
AG
W
HEN
E
MPTYING
,
S
HARP
D
EBRIS
C
AN
C
AUSE
I
NJURY
3. Flip the debris fin back into place before re-fitting
as described on page 3.
N
WARNING Never use water for cleaning your product,
use only a dry cloth. Do not clean with chemicals or
solvents, some can destroy critical plastic parts.
After Using Your Gardenvac (Q1, 2, 3 & 4)
1. Switch off and disconnect from the mains electrici-
ty supply before cleaning your product.
2. Always empty the debris bag.
3. Take extra care to clean around the cutting head
and the collection chute.(Q1)
• Take care when cleaning around the cutting
line area - sharp edges can cause injury.
4. Inspect the cutting line and replace if worn or
damaged
5. Using a soft brush remove debris from all air
inlets. (Q2)
6. Remove dirt and debris from debris fin.with a suit-
able tool. (Q3)
7. Wipe over your product with a soft dry cloth. (Q4)
Replacing the Cutting Line (Q5 & 6)
• Switch off and disconnect from the mains elec-
tricity supply before replacing the cutting line
• Handle the cutting line with care - sharp
edges can cause injury.
1. Remove debris bag from product. See Page 4.
2. Remove cutting line (Q5) and discard safely.
3. If the cutting line becomes broken during use -
use a suitable tool to lever the line out of location.
(Q6).
4. Place the cutting line into the slot in the cutting
head. Ensure the cutting line is correctly located.
See Page 3.
5. Re-fit debris bag to product. See Page 3.
Storing Your Gardenvac
Always store the product in a dry place ensuring the
cable is not likely to be damaged on sharp edges etc.
Q1
Q2
Q3
Q4
Q5 Q5
Caring for your Gardenvac