Filter
Top Products
– 41 –
Speed Key (Macros)
General Information
The “A”, “B”, “C”, and/or “D” keys can be used to activate a string of
commands up to 32 keystrokes each. These commands are known as a macro
and are stored in the system’s memory. Typical Speed Key functions include:
• Arming sequences that involve first bypassing certain zones before
arming.
• Seldom used but repeatable sequences.
• Relay activation sequences.
Defining
To program a macro, enter your user code + [#] + [D]. The following appears:
ENTER SPEED KEY #
01-32 00=QUIT
Enter the 2-digit Speed Key number (01-32) being defined and press [*].
Enter up to 32 keystrokes. A Speed Key sequence can include different
commands. Press the "D" key to separate different commands. For example,
you may want to perform the following sequence.
GOTO partition 2
......................
Enter *2
Bypass zones 010 & 011
...........
Press bypass [6], then the zone numbers 010
& 011
Arm in maximum mode
............
Press maximum [4] key
Return to partition 1
.................
Enter *1
To program that Speed Key sequence, type the following:
*2 D
6010011 D 4D *1 D D
Note that the "D" key is pressed after each command. Press "D" twice to
complete the entry and exit.
NOTE: When defining Speed Key sequences, do not use the [#] key to
represent Quick Arming. The system uses the code entered in
response to the prompt to initiate commands in a Speed Key
sequence, so the quick arm key is unnecessary. The system
interprets the use of the [#] key in a Speed Key sequence as its
designated function only.