Filter
Top Products
Release
Button B
Attachment Clamp
Caution: When using one of the attachments during cleaning, set the vacuum
cleaner to the upright position.
1
2
3
USING THE ATTACHMENTS
Press the release button B to
disconnect the handle from the
vacuum cleaner.
Remove the attachments from the vacuum cleaner.
Caution:
When removing the attachments, pull
them in the directions shown in the
illustration. Pulling them in the wrong
direction or pulling them forcefully may
cause damage to the attachment clamp.
Attach the attachments as shown below.
8
Hook the hose holder onto the holder mount.
Caution:
Before using the attachments, please make sure
the hose is hooked on the holder mount.
When you have finished using the attachments,replace them
in their original positions as shown on page 4.
Tabs
Groove
Upholstery tool & Dusting brush
To detach the dusting brush from the upholstery tool: Press the
tabs on the brush downward to remove it.
To reattach the dusting brush to the upholstery tool: Insert
the front of the upholstery tool under the hook on the front of the
dusting brush. Press down on the back of the upholstery tool to
snap it into place under the dusting brush tabs.
Attach the attachments on the handle or
the suction hose B.
Caution:
Before using the suction
hose B, please make
sure the handle is
reattached on the body.
Hose
Holder
Holder
Mount
The wand and crevice tool are
contained together.
Pull out the crevice tool as shown.
Wand
Crevice Tool
Suction Hose A
Wand
Crevice Tool
Upholstery
Tool
Dusting
Brush
Suction Hose B
Handle
Duster
Turbo Brush
Bare Floor Brush