Filter
Top Products
The front surround will need to be removed in order to change
lamps.
Warning -The front surround is heavy and easily damaged !.
The front surround is fixed with 4 spring loaded pins and is
supported at the top by the chassis.
To gain access to the lamps please apply the following proce-
dure:
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE REMOVING LAMPS.
Lamp Replacement
Fig. 12
Fig. 10
Fig. 11
While holding the surround by its sides with both hands, care-
fully pull forwards the surround at the bottom until the pins
detach from the clips (see Fig. 9).
When the bottom holding pins are undone, carefully pull for-
wards at the top until the top pins detach and then lift the
surround up and out (see Fig. 10).
For access to the bottom bulbs, carefully slide the flexible ro-
tisserie to one side ensuring that the rubber grommets are
not lost (see Fig 11).
Remove the defective lamp by unscrewing it (see Fig 12).
Replace with a 60W E14 SES clear candle bulb, rotating it.
Take care not to over tighten the bulb.
Spring clip
Holding Pin
Fig. 9
Spring clip Holding
Pin
Chassis
bracket
Chassis
Grommet
Rotate flexible
Rotisserie out of
position
Flexible Rotisserie
rotated out of position