Filter
Top Products
Replacing the remote control
The new remote control must be set up as follows:
Press switch 1 to ON .
Press switch 2 to AUTO (see Fig. 6).
Press switch 3 to O for more than 3 seconds until both LED’s
are on (see Fig. 7).
Press the remote control’s enter button or the e f buttons.
Now the heater has learned the serial number from the remote
control and will work with this remote control only (this
procedure is repeatable many times).
General information
1. In case that the remote control is out of order or the
batteries need replacing the fire will stop automatically after
3 minutes.
2. If the batteries are changed the programme memory
remains but the time has to be set (see Time setting).
Important Battery information.
Discard leaky batteries.
Dispose of batteries in the proper manner according to
Provincial and local regulations. Any battery may leak
electrolyte if mixed with a different battery type, if inserted
incorrectly, if all the batteries are not replaced at the same
time, if disposed of in a fire or if an attempt is made to
charge a battery not intended to be recharged.
10. An entered program can be checked, edited and deleted
just by navigating again into the PROG menu and
pressing the enter button. With the
--
--
- buttons the
different program numbers can be selected. To delete
one program number, press the f button. The CP symbol
(clear program) appears and by pressing the enter button
~ the current program will be deleted. e f leaves the
menu without deleting the program.