Filter
Top Products
Excalibur
®
P90 Zero Clearance Direct Vent Gas Fireplace 29
5th Grate Tab
02-54
5) Position Log 02-53 across the cutouts in
Logs 02-75 and 02-51 with the notch on the
left side of the log fi tting into the 2nd grate
tab.
Cutouts
2nd Grate Tab
02-53
02-75
02-51
02-51
02-53
02-53
02-51
Notch
Bracket
Bracket
02-5102-75
4) Place Log 02-51 on the front right side of
the burner. Push the back of the log against
the 2 brackets with the notch on the bottom
right side of the log fi tting into the right side
of the grate.
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken do
not use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
The gas log kit (Part # 780-930) contains the
following pieces:
a) 02-75 Rear Log
b) 02-55 Middle Left Log
c) 02-50 Front Left Log
d) 02-53 Center Left Log
e) 02-51 Front Bottom Log
f) 02-54 Center Right Log
g) 02-52 Middle Right Log
h) Embers 902-156
NOTE: If you will be installing the optional
Brick Panels, install the Brick Panels
prior to installing the logs.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite all over the top of
the base brick panel.
3) Place the Log 02-75 on the rear log support
pins with the fl at side to the back.
The "02" refer numbers (i.e. 02-75) are
molded into the rear of each log.
OPTIONAL
BRICK PANELS
1) Open the bottom louver door. Loosen the 2
screws holding the Burner ON/OFF switch
and bracket to the bottom louver and lift the
assembly out.
2) Remove Arch Surround.
3) Remove glass door. Remove logs.
Note: The logs must not be in the unit.
4) Insert the back brick panel fi rst by carefully
slipping it between the back wall of the
fi rebox and the rear log bracket.
5) Put the side panels in next. Slide them in
from the front and push them fl at up against
the wall. Be very careful not to scratch them
on the fi rebox hardware.
6) Install the 2 brick retaining clips, one on
each side.
02-75
Note: If the bottom brick panel must be removed:
Remove the Rear Log Stand, then remove
the Burner Tray. See the "Removing Valve"
section.
02-75
02-54 02-52
02-50 02-53 02-51
02-54
02-51
Notch
6) Position Log 02-54 across the cutouts in
Logs 02-51 and 02-53. The notch in the
bottom right end fi tting against the 5th grate
tab.
INSTALLATION