Filter
Top Products
5
www.sharkclean.com
Using Your Sonic Steam Pocket
™
Mop
IMPORTANT: Do not use the mop without
attaching a cleaning pad and adding water
to the tank first. When you are using the mop
for the first time, it might take longer than the
normal 30 seconds to start steaming. Just pump
the handle a few times in a downward motion to
prime the pump.
2 Pump the handle a few times in a downward
motion. This pumping action will release steam
as you mop and allows you to customize the
amount of steam you want. Begin mopping with
a forward and backward motion. The natural
motion of mopping will produce steam. (Fig. 8)
NOTE: The steam mop is on when it is plugged
in. Unplug when you want to turn it off.
NOTE: The Sonic Agitation On/Off button is
only for activating the sonic agitation function of
the steam mop. It does not turn the appliance on
or off.
NOTE: Make sure the floors are swept or
vacuumed before using the Sonic Steam
Pocket
™
Mop.
Visit www.NavigatorClean.com for other great
quick cleaning products to complement your
Steam Mop, such as the Shark
®
Navigator
™
Lift Away
®
vacuums.
1 Pull and twist the quick release cord holder to
unwrap the power cord completely. (Fig. 6)
Plug into a 120-volt electrical outlet. The Power
“On” Light around the Sonic Agitation button
will turn blue. (Fig. 7)
It takes approximately 30 seconds for the mop to
heat up and the steam to be ready.
fig. 6
fig. 8
fig. 7
Pump for
steam
SM200_11_IB_ENG_120608_1.indd 5 12-06-08 4:12 PM