Filter
Top Products
Operating Instructions - Components
On/Off Switch:
The unit is “On” when the switch (#2) is in the “Pushed down” position. The unit is “Off” when the switch is in
its “Up” position.
Safety Cap (#1)
In order to open the Safety Cap, first press it down and then turn counter clockwise.
Caution:
Read the instruction for “Filling the Water Tank” before opening the Safety Cap.
Steam Strength Regulating Knob (#8)
This knob adjusts the amount of steam coming out of the nozzle. Turning the knob clockwise will increase the
steam flow to its maximum.
Steam Indicating Light (Yellow) (#3)
When this light is “On”, it indicates that the steam is ready to use.
Important:
This light will go “On” and “Off” during usage showing that the steam is being generated.
Add Water Light (Red) (#4)
This light will go “on” when the water level is low.
Important:
Before adding water, read the instructions for adding water.
Depending on the ambient room temperature, this light might go on for a short period during initial tank heating.
On/Off Steam Switch (#7)
Setting this switch to the “On” position will start the flow of steam.
Caution:
The On/Off Steam Switch located on the handle must be in the “Off” position before attaching or
disassembling accessories.
Starting Your Vapor Steam Cleaner
CAUTION: Do not plug in the machine during filling. Use a grounded receptacle. Use
only a heavy duty extension cord rated for 15 amps - Do not use an ordinary
extension cord.
Filling Your Steam Generator With Water
Step 1: Press down Filler Cap (#1) and turn counter clockwise until removed.
Step 2: Place Filler Funnel in tank and add two quarts/liters of clean tap water. Do not overfill.
Replace Filler Cap by turning clockwise - press down firmly to tighten. It is ok to
use hot water. This reduces heating time.
Step 3: Plug the machine into a standard 120 volt wall (3-prong) receptacle. Depress
Heater On/Off Switch (#2).
5