Filter
Top Products
Changing the Motor Protection Filter
Changing the Air Output Hepa Filter
The air output Hepa filter (8) must be replaced once or
twice a year depending on usage. Open the rear air output
Hepa filter cover (7) by pressing on the “Push” and tilting
the cover to open. Remove the filter. Never operate the
vacuum cleaner without the air output Hepa filter. Refit the
filter and return the cover to position by pushing down on
the two latches. Before closing the cover, it is better to pull
out the cord a little bit so that the plug does not obstruct the
cover from closing. (See fig. 14)
To Order Additional Bags & Filters
To order replacement bags and filters, or for customer service, call
EURO-PRO Operating LLC Customer Service at:
Tel.: 800-798-7398
Monday to Friday 9:00 A.M. to 5: P.M. Eastern Standard Time
or
visit our website: www.sharkvac.com
Fig. 13
The motor protection input filter (11) should be changed once or twice a
year, depending on the usage of the vacuum cleaner. To remove the
filter, first open the bag compartment cover (1), then take out the dust
bag (17). Under it you will find the motor protection input filter (11).
Remove the filter by pulling it up. (See fig. 13)
Knock the dust of the motor protection input filter (11) thoroughly or
wash it if it is very dirty, making sure that it is completely dry before
refitting. Never use the vacuum cleaner without the motor protection
input filter.
Fig. 14
7
Motor Thermostat
IMPORTANT: This motor is equipped with a heat sensitive thermostat. If for some
reason the vacuum cleaner will overheat, it will then stop working
automatically. When the motor will cool off, the unit will restart by itself.