Filter
Top Products
Using the Vacuum Cleaner
• Before starting the vacuum for the first time, check that the dust
bag (17) and the filters (8 & 11) are properly set in place.
Note: A safety catch on the dust bag support (2) prevents the
cover from being closed if the dust bag (17) is not in place.
Make sure that the dust bag (17) is properly inserted and the
cover is closed before using the vacuum.
• To open the bag compartment cover (1),put your hand under the
cover (1) and lift up. (See fig. 1)
• To close the bag compartment cover (1), press downward on the
cover with your hand on top of the cover (1), until you hear a click.
• Fit the flexible hose (12) into the cleaner hose coupling hole (3) and turn
it right until it is secured in its place. (See fig. 2)
•The accessories fit directly on the tube handle (10) or may be used
with the extension tubes (14) to reach further away.
• Attach the deluxe turbo brush floor attachment (23) to the end of the
telescopic tube (14). (See fig. 3)
• Now you may plug the vacuum into the wall outlet. To do this, pull out
as much of the power cord as you need. Start the vacuum cleaner by
pushing on the on/off button (6). (See fig. 4)
• When you are finished vacuuming, switch the vacuum cleaner off by
pushing the on/off button (6). (See fig. 4)
• Unplug the vacuum and rewind the cable by pushing the cord rewind
button (5) (See fig. 5) Hold the plug when rewinding the cord. Do not
allow the cord to whip when rewinding. If the cord does not fully retract,
pull it out again and then press on the cord rewind button (5) again.
• The suction regulator (19) shown in Fig. 6 allows you to regulate the
amount of suction obtained from the vacuum cleaner.
Warning: Hold the plug when rewinding the cord. Do not allow
the cord to whip
when rewinding.
Fig. 1
Fig. 3
Fig. 4
Fig. 5
Fig. 6
4
Fig. 2
Fig. 2