Filter
Top Products
Replacing the Dust Bag
When the “dust bag full” indicator (4) becomes red, the dust bag should be
replaced.
• Open the bag compartment cover (1) by putting your hand under the
cover (1) and lifting it. (See fig. 7)
• Push back the black plastic tabs (A) towards you. This will release the
cardboard base of the dust bag from the hooks (B), and allow you to slide
the full bag upwards. (See fig. 8)
• To fit a new bag in the compartment:push the black plastic tabs (A)
backwards. Slide in the empty bag. Make sure that the hooks (B) are
holding the cardboard base of the dust bag. (See fig. 8)
• Close the bag compartment cover (1).
Warning: To reduce the risk of electric shock, the power cord must be
disconnected before changing the bag or filter, or performing
maintenance/trouble shooting checks.
NEVER OPERATE WITHOUT DUST BAG IN PLACE.
If you are using the cloth bags instead of the paper bags, the bags can be used and emptied
repeatedly. For removing and inserting the cloth dust bag, follow the same instructions as for
the paper bags above.
NEVER REUSE PAPER BAGS.
Suggestion: When vacuuming new carpets or carpets with fine powders on them, the powder
may clog the dust bag, therefore, check the bag more often.
Note: The bag compartment cover (1) will NOT close if no bag is installed in the
vacuum cleaner.
AA
B
Fig. 7
Fig. 8
5