Filter
Top Products
5
HOW TO ASSEMBLE
CAUTION: Moving parts, make sure on/off switch is in off position before plugging in.
CAUTION: Assemble the cleaner before using.
NOTE: Features may vary by model yet all parts assemble the same.
1. Before placing the front cover on the unit, install the
hose.
2. Locate the tab on the hose adapter (shortest end).
3. Look at the opening on the top of the cleaner and locate
the ledge. The tab on the hose adapter will be under the
ledge in the opening when hose is installed properly.
4. Push hose adapter into opening and rotate until tab is
under ledge. If installed properly, the hose cannot be
lifted out of the hose opening.
Step A Attach Handle
CAUTION: Do not catch cord under handle.
1. From rear of cleaner, align handle with groove and
slide onto cleaner. If necessary, use thumb and finger
pressure to slide handle into position.
2. Once handle is in place, check that the electrical cord
is not pinched between the unit and the handle. Push
excess cord back into the hole provided in the back of
the handle.
3. Attach handle with two 5/8 inch screws in the assembly
packet. Use a Phillips
®
head screwdriver.
Groove
Step B Attach Hose
1
1
Electrical
Cord
Groove
2
3
Ledge
2
3
Tab