Filter
Top Products
How to Use Charger on Shelf or Countertop
Charge the Batteries
1. Turn the nozzle down and
lower the cleaner onto the
bracket.
2. When the charge light
lights up it indicates that
the battery in the unit and/
or an extra battery is
charging.
NOTE: Charge the batteries for 14-16 hours before initial use. A cleaner may lose
charge in shipment. The plug charger will become warm, however, this is
not a cause for concern.
NOTE: If the batteries are completely void of charge, the charging light may not
shine until there is sufficient charge in the batteries to provide power.
It is all right to leave the cleaner on constant charge so it is always ready to use. Unplug
only if it will not be in use for several weeks at a time.
6
This charger has been designed to use as either a wall
mounted charger or to sit on a counter or shelf. To use
on a counter or shelf, locate next to an electrical outlet.
Take the battery out of the cleaner and put in the charger
stand as shown to the right. The charge light will indicate
that the battery is charging.
Charge Light
for Unit
Charge Light for
Extra Battery
Battery
Rear View
Nozzle
1. Hold bracket against wall to mark location
for screws. Make sure the wall bracket is
positioned vertically, with the charger
socket at the bottom. See Fig. 1.
2. Use a 1/4 inch drill for drilling holes for the
plastic anchors.
3. Insert the anchors and drive the screws
into both holes.
4. Tighten the screws to secure the bracket.
5. Place cleaner, with the nozzle pointed
down, on the wall bracket, Fig. 1.
6. Plug the charger into an electrical outlet.
HOW TO ASSEMBLE (continued)
Secure Wall Bracket on Wall
Cleaner hangs in bracket with the nozzle end down. Mount on a wall where there are no
dangerous objects hidden beneath the wall surface like electrical wires, pipes, etc. Leave
14 inches above the floor for clearance.
Fig. 1
NOTE: You can charge a battery in the unit and an extra battery (optional) at the
same time.