Eureka 910 Vacuum Cleaner User Manual


 
ENGLISH
Caution: Risk of Injury. Do not use Dust container
handle to carry cleaner.
INSTRUCTIONS FOR USE
Do not operate without the lters in place.
Pull all of the power supply cord out from back of cleaner and plug
into electrical outlet.
Note: When pulling on power supply cord watch for a yellow line on
the cord. Then continue slowly pulling on cord till you see the red
line, stop. The red line indicates the end of usable cord.
Turn the ON/OFF button to switch the cleaner on. (I) is ON/ (O) is
OFF.
To rewind the power cord, press the rewind button with foot and
guide the cord with hand to ensure that it does not whip causing
damage.
By moving the suction control dial, the suction power can be ad-
justed.
Suction can also be regulated on the hose handle by opening / clos-
ing the button.
HOW TO USE
Floors should be cleaned regularly over heavily traveled areas, and once
a week over the entire area. Vacuum slowly, making several passes (for-
ward and backward), covering small areas at a time. The time required to
clean will depend on several factors - including type of oor and amount
of dirt.
Cleaning Tools
1 Combination Crevice Nozzle/Brush Tool*: (stored on tool clip on
wand): For crevices, corners, baseboards, between cushions. Brush
rotates to allow use as brush or crevice depending on task.
2 Upholstery Nozzle*: (stored on tool clip on wand): For curtains,
draperies, cushions, fabrics.
3 Turbo Brush*: For upholstery and for stairs.
4 Bare Floor Brush*: For any type of hard surface oor.
5 Dual Purpose Floor Nozzle: Use foot to change from
hard surface to carpet setting
6 Hose Suction Control Button: For use to increase or decrease suc-
tion when using cleaning tools.
* Depending on the model
Carry Handle
Dust Container
Handle
1*
2*
5
6
3* 4*
4
*
Hose Suction
Control Button
10
!