Filter
Top Products
Eureka Customer Service HELPLINE 1-800-282-2886
www.eureka.com
4
Brush Roll Reset Button
1) Clear interference that caused
brush roll to stall.
2) Press reset button on the side of
vacuum below brush roll cover
(Fig. 7).
How to replace brush roll or belt
1) Adjust carpet height setting to the
lowest or highest position.
2) Press handle release twice to lower
handle flat onto floor (Fig. 1).
3) Turn vacuum over.
4) Remove 6 screws from the backside
of cover (Fig. 2). One screw is
located under the wheel carriage.
5) Turn vacuum back over to front side
and lift off brush roll cover (Fig. 3).
6) Lift left end of brush roll first.
Remove old brush roll and belt.
7) Thread belt around motor shaft
(Fig. 4). Place belt around the
pulley of new brush roll.
8) Align brush roll left end cap with
base and push into place. Push right
end cap into base until it snaps into
place (Fig. 5).
9) Rotate brush roll 2 turns to position
belt properly.
10) Replace brush roll cover (Fig.3).
11) Turn vacuum over and replace 6
screws (Fig. 6).
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 1
How to Maintain Your Vacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged
Check Cogged Belt. Replace if worn or broken
Avoid touching the motor shaft when checking brush roll or belt.
!
!
Maintain Brush Roll
Motor can become hot with normal use.
Do not remove end caps. Remove hair and threads from brush roll periodically.