Filter
Top Products
035-18496-000-C-1102
4 UnitaryProductsGroup
GENERAL
The LA and LB evaporator units are designed for use with the
HA/HB Series condensing units.Units are designed to match
up with LA/LB series Evaporator Blowers to meet ASHRAE
90.1 standards.
Each unit consists of a coil section and a blower section that
are factory assembled and shipped as shown in figures 3 and
4. These sections may be rearranged in the field for other air
discharge patterns. See figures 7, 8 and 9.
The LA and LB evaporator units have 24 volt normally closed
solenoid valves to match the 24-volt control circuits of the
Simplicity
TM
control board in the HA300 as well as the
HB360, HB480 and HB600 condensing units.
NOTES, CAUTIONS AND WARNINGS
Installer should pay particular attention to the words: NOTE,
CAUTION and WARNING. Notes
are intended to clarify or
make installation easier. Cautions
are given to prevent
equipment damage. Warnings
are given to alert installer that
personal injury and/or equipment damage may result if instal-
lation procedure is not handled properly.
REPLACEMENT PARTS
Refer to parts manual for complete listing of replacement
parts on this equipment. The above forms and all other forms
referenced on this instruction may be ordered from;
Standard Register
2101 W. Tecumseh Road
Norman, OK 73069
Telephone : (877) 318-9675
Toll Free Fax: (877) 379-7920
INSPECTION
As soon as a unit is received, it should be inspected for possi-
ble damage during transit. If damage is evident, the extent of
the damage should be noted on the carrier's freight bill. A
separate request for inspection by the carrier's agent should
be made in writing.
LIMITATIONS
This unit must be installed in accordance with all national and
local safety codes. If no local codes apply, installation must
conform to the appropriate national code. The unit is
designed to meet National Safety Code Standards. If
components are to be added to a unit to meet local codes,
they are to be installed at the dealer's and/or the customer's
expense. See Table 1 for unit application data.