Filter
Top Products
Troubleshooting
1) Unit does not operate at any speed setting:
• Polarized cord must be fully inserted in wall outlet.
• Check refill switch operation, by unplugging unit, remove Motor
Chassis, place on side and move refill switch lever. If you do not hear
the switch “click” service may be required.
• Refill with water if necessary.
• Humidistat not set properly - set humidity to a higher level.
• Check the airflow path. Are there any obstructions preventing
movement of the fan blade?
• The motor contains a temperature-sensing fuse. If the motor becomes
overheated, the fuse may trip. Unplug the unit and contact the nearest
authorized service station. DO NOT ATTEMPT to repair the motor yourself.
2) Not enough humidity:
• This is an evaporative humidifier. The humidity is invisible
.
• Check the condition of the evaporative wick. Replace if clogged or
hardened with minerals.
• The water reservoir may be empty - refill.
3) Too much humidity:
When condensation becomes heavy on cold surfaces in the room, turn
the unit to a lower humidistat setting or increase the room temperature.
4) Water Leak:
The cabinet was overfilled. For your safety an overflow hole is
provided in rear of cabinet. Correct water level is marked on wick
frame and cabinet side wall.
5) Odor:
Clean and disinfect cabinet reservoir following CLEANING AND
DISINFECTING INSTRUCTIONS. Use Bemis by Essick Air Bacteria
Treatment to help eliminate unpleasant odors.
6) T
he electronic module on Model 821 Series is not consumer serviceable -
contact Bemis by Essick Air Customer Service for assistance.