Filter
Top Products
24632-0-0508Page 18
5
MARKING FOR
WALL HOLE
MARKING FOR
WALL MOUNTING
PLATE HOLES
FLOOR LINE
MARKING FOR
GAS INLET HOLE
4
Remove the template from the wall after the holes are marked.
The hole location markings will be present on the wall.
Housewarmer recommends the use of the wall template to properly cut the wall holes and place the heater. If the template is
damaged or not included, refer to the table and graphic below for proper alignment of the wall holes and heater.. Be sure the
baseboard does not get in the way.
MEASUREMENTS
Model HWDV080(B)DV HWDV181(B)DV
C 7 3/8" 11 3/8"
D 10 7/8" 10 7/8"
E 21" 24 1/2"
F 9 1/4" 9 1/4"
G 4" 4"
I 6 1/4" 6 1/4"
INTERIOR PREPARATION AND INSTALLATION OF THE BACK OF THE UNIT