Filter
Top Products
24632-0-0508 Page 17
2
INTERIOR PREPARATION AND INSTALLATION OF THE BACK OF THE UNIT
Locate the wall mounting plate template included in your kit
and remove the perforated sections. Use painters tape to secure
the wall mounting plate template onto the interior wall where
the heater will be located. (Template for HWDV080 will be on
the opposite side of the shown template.)
MOUNTING TEMPLATE FOR
SEE OTHER SIDE FOR HWDV080
1
Before installing unit, remove wall mounting plate from back of unit.
3
Trace the template wall hole and (if applicable) the gas inlet hole onto the wall. Mark the six (6) wall mounting plate screw
holes onto the wall. The size of the gas inlet hole will depend upon the size of gas pipe coming into the unit. (See page 17,
box 2 and page 18, box 4).