Filter
Top Products
This is used to regulate the airflow through the pellet
stove.
• On the low heat output settings, push the slider all
the way in.
• On the high heat output pull the slider out or until a
good fire is achieved. A good fire is in between a fire
with lazy black tipped flames and a forced fire (very
quick, shorter flames). A good fire is the most efficient
and will have a bright and active flame.
• Slider should be set at a hot magnehelic reading of
0.14” W.C. (34 Pa) for firebox vacuum.
9
Figure 10
Installation
All local regulations, including those referring to national and European Standards need to
be complied with when installing this appliance.
DECIDING WHERE TO LOCATE YOUR PELLET APPLIANCE:
1. Check clearances to combustibles to the unit and for the venting as per the pellet vent manufacturer’s
installation instructions.
2. Do not obtain combustion air from an attic, garage or any unventilated space. Combustion air may be
obtained from a ventilated crawlspace.
3. Do not install the stove in a bedroom.
4. You can vent the stove through an exterior wall behind the unit or connect it to an existing masonry or
metal chimney (must be lined if the chimney is over 6” in diameter, or over 28 inches² cross sectional
area). An interior vent can be used with approved pipe passing through the ceiling and roof.
5. Locate the stove in a large and open room that is centrally located in the house. This will optimize
heat circulation.
6. The power cord is 8 feet (2.43 m) long and may require a grounded extension cord to reach the
nearest electrical outlet.
REMOVING YOUR NEW STOVE FROM THE PALLET:
To remove your new stove from its pallet you must remove both cabinet sides. This is done by the
following steps (refer to Figures 7, 8, and 9 in the section Specifications - Safety Devices):
1. Loosen the three (3) screws from both sides on the back of the appliance.
2. Remove the ash pan cover.
3. Remove the four (4) screws, two (2) on each side, next to the ash pan holding the cabinet sides on.
4. Slide cabinet sides forward and out.
5. Remove the two (2) screws, one on each side, that are holding the base of the unit to the pallet.
6. Remove the unit from the pallet.
7. Replace cabinet sides using the reverse of the method used to remove them.
8. Replace the ash pan cover.
SLIDER/DAMPER OPERATION: