Filter
Top Products
HOW TO START AND OPERATE YOUR PELLET APPLIANCE
1. Check and fill hopper with pellets.
2. Switch on power by pushing the start
up switch once only.
3. Turn the Dial A Fire knob to the 12
o’clock position. (Lower grade
pellets may need a higher setting
on the feed rate). NOTE: unit will
take longer to light if the hopper has
been completely emptied.
CONVECTION
BLOWER SPEED
CONTROL
4. Wait until the fire is established, then
turn knob “B” to the desired heat
output. (The stove may not be able to
burn in the BLUE ZONE if poor
quality wood pellets are being used.)
Adjust the Slider Damper to the
appropriate setting.
AUGER LIGHT
START-UP
SWITCH
5. If the stove should shut off after 15
minutes and there is still a fire in the
firebox – press the start up switch
once more. If the fire went out, return
to step number 2 and re-light the
stove.
DIAL-A-FIRE
HEAT
OUTPUT
KNOB
6 Adjusting the blower speed control
knob will vary the rate of airflow into
the room by varying the speed of the
convection blower. *Note: The
convection blower may cycle to high
automatically depending on the
setting of the controls. This is a
normal safety feature of the unit.
TURNING YOUR PELLET STOVE OFF
To turn your stove off, simply turn the HEAT OUTPUT knob (knob “B”) counter-clockwise until the knob
clicks to the “off” position. This will stop the feed of pellets. The blowers will continue to run and cool
the stove. When cool enough the stove will shut down.
SPECIAL NOTES:
- The flashing green light corresponds to the auger feed rate.
The scale on the Dial A Fire knob represents a range, not exact at times. Wood pellets of differing
quality may effect the performance of the stove. If the stove has trouble operating at the end of its
range, turn the heat output knob back slightly.
6