Filter
Top Products
19
1.
Choose a stove location that is ideal. See the section Deciding Where to Locate Your Pellet Appliance.
2.
Place the unit on the hearth pad (if installed on a carpeted surface) and space the unit in a manner so
when the pellet vent is installed vertically, it will be 3” (7.6 cm) away from a combustible wall.
3.
Locate the center of the fresh air intake pipe on the unit. Match that center with the same point on the
wall and cut a hole about 2 ” (5.4 cm) in diameter.
4.
Install the fresh air intake pipe.
5.
Install the tee with clean out.
6.
Install the pellet vent upward from there. When you reach the ceiling, make sure that the vent goes
through the ceiling fire stop. Maintain a 3” (7.6 cm) distance to combustibles and keep attic insulation
away from the vent pipe. Maintain an effective vapor barrier
7.
Finally, extend the pellet vent to go through the roof flashing.
8. Ensure that the rain cap is approximately 36” (91.4 cm) above the roof.
9. The same methods apply for vertical installation outside. Install wall thimble and pipe supports.
Installation
VERTICAL INSTALLATION: