Filter
Top Products
OPTIONAL FAN INSTALLATION
The appliance when installed, must be electrically connected and grounded in accordance with local codes or in
the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part 1, SAFETY
STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI / NFPA 70 in
the USA.
CAUTION
Label all wires
prior to
disconnection
when servicing
controls. Wiring
errors can cause
improper and
dangerous
operation. Verify
proper operation
after servicing.
1) Remove the fan assembly from the box and
inspect for any damage to the assembly.
2) Remove the metal knock out on the rear of the
appliance.
3) Install two screws into the top two holes. Place
the blower assembly over these two screws
and tighten. Install the two bottom screws and
tighten.
4) Plug the fan assembly in and check for proper
operation.
DO NOT cut or remove the grounding prong from the plug. Also do not route the power cord beneath the heater.
WARNING: ELECTRICAL GROUNDING INSTRUCTIONS.
This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and
should be plugged into a properly grounded three-prong receptacle.
WIRING DIAGRAM
This is a basic wiring diagram for the option fan installation. Models 1000, 1600, 2100 Freestanding units only.
1) Plug the fan assembly into a three
prong (grounded) receptacle.
2) Turn the fan controller to the desired
setting.
3) Once the unit has reached operating
temperature, the fan temperature
sensor will turn the fan on
automatically.
4) When the unit cools down the fan
temperature sensor will shut the fan
off automatically.
15