Enviro 1000 Stove User Manual


 
FREESTANDING
INSTALLATION:
CHIMNEY:
Vent the stove into a clean, lined, approved
masonry chimney in good condition, conforming
to local building codes or a listed 6” factory built
chimney suitable for use with solid fuels and
conforming to, ULC-S629 in CANADA or UL-
103HT in the U.S.A.. Connect the stove to this
chimney with a short and straight 6” (150 mm),
25 gauge or heavier, single wall black or blued
steel smoke pipe. Connection to all masonry
chimneys must be a metal or masonry thimble
cemented in place. All smoke pipe must slope
upwards, all connections must be tight and
secured with three sheet metal screws equally
spaced. The smoke pipe length should not
exceed 40% of the chimney height above the
stove.
A non-combustible floor protector is required
under all freestanding units. The floor protection
must extend 18” (457 mm) in front of the unit
and 8” (203 mm) to each side. When venting into
a masonry chimney the floor protector must be
installed directly below the chimney vent and 2”
(50.8 mm) on either side of the chimney vent.
DO NOT CONNECT THIS UNIT TO A
CHIMNEY FLUE SERVING ANOTHER APPLIANCE.
MAINTAIN THESE MINIMUM CLEARANCES TO UNSHIELDED COMBUSTIBLES*
DOUBLE WALL
PIPE**
DOUBLE WALL
PIPE**
MODEL 1000 MODEL 1600 MODEL 2100 MODEL 1000 MODEL 1600
A. SIDE TO UNIT 19 “ (485 MM) 20” (510 MM) 22” (560 MM) 14” (355 MM) 11” (280 MM)
B. REAR TO UNIT 10” (2556 MM) 12” (300 MM) 12” (300 MM) 6” (150 MM) 4” (101 MM)
C. CORNER TO UNIT 6” (150 MM) 6” (150 MM) 8” (200 MM) 2” (50 MM) 6” (150 MM)
D. SIDE TO COLLAR 28” (710 MM) 29” (735 MM) 31” (790 MM) 23’ (585 MM) 20” (508 MM)
E. REAR TO COLLAR 13” (330 MM) 16.5” (420 MM) 16.5” (420 MM) 9” ( 230 MM) 8.25” (210 MM)
F. CORNER TO COLLAR 16” (405 MM) 16.5” (420 MM) 19 “ (485 MM) 11.5” (290 MM) 15.5” (394 MM)
CAUTION: AN UN INSULATED SMOKE PIPE MUST NOT PASS THROUGH AN ATTIC, ROOF SPACE,
CLOSET OR SIMILAR CONCEALED SPACE, OR THROUGH A FLOOR, CEILING, WALL, OR PARTITION,
OR ANY COMBUSTIBLE CONSTRUCTION.
*ALL CLEARANCES CAN BE REDUCED WITH SHIELDING ACCEPTABLE TO THE LOCAL AUTHORITY.
**DOUBLE WALL: IN CANADA:
ANY ULC-629 LISTED CHIMNEY SYSTEM WITH THE ACCOMPANYING
LISTED DOUBLE WALL VENT CONNECTOR.
IN U.S.A.: ANY HT-103 LISTED CHIMNEY SYSTEM WITH THE ACCOMPANYING
LISTED DOUBLE WALL VENT CONNECTOR.
9