Filter
Top Products
Proper Impingement (Baffle) Plate Placement in Pellet Stove Firebox
Occasionally in shipping, the impingement (baffle) plate may shift out of its proper position. If this
is the case with your stove, follow these instructions to return the plate to its proper position.
1. Remove the plate from the stove, holding the plate by its tab handle, with the cutout notch facing
upwards.
2. Turn the notched end into the doorway (as shown above), and lift the plate up to allow the bottom
of the plate to fit in the doorway.
3. Let the bottom of the plate rest on the firebox, and then push the bottom of the plate flush against
the back wall of the firebox. At this point, the plate will lean forward (toward the front of the stove)
slightly, and will come in contact with the front of the stove above the door.
4. Finally, center the plate on the firebox, so that it will be centered above the fire when the stove is
in operation.
Technical Support: (800) 245-6489
www.englanderstoves.com
Notes on termination of Pellet Vent Pipe (see also “FLUE SYSTEM” section of manual):
1. Not less than three (3) feet above any forced air inlet located within ten (10) feet.
2. Not less than four (4) feet below, four (4) feet horizontally from, or one (1) foot above any
door, window or gravity air inlet into any building.
3. Not less than two (2) feet from an adjacent building, and not less than seven (7) feet above
grade where located adjacent to public walkways.
The exhaust exit shall be arranged so that the flue gases are not directed so that it will
affect people, overheat combustible structures, or enter buildings. Forced draft systems
and all parts of induced draft systems under positive pressure during operation shall be
installed gastight or to prevent leakage of combustion products into a building. Vents shall
not terminate where condensate or vapor could create hazards or a nuisance.
Be sure to follow local codes and all manufacturers’ instructions (including exhaust pipe).
Consult a professional installer and/or call Technical Support if you have any questions.
6