Filter
Top Products
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND’S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE
TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
16
FUEL CHANGE PROCEDURE
When starting the stove with corn, push the “AIR ON TEMP” button and hold, which will rotate the
Stirrer mechanism in the burnpot. Release the button when the 4-prong side of the Stirrer is straight
up (in the “12:00” position, as shown in Illustration 2, page 13). Then follow the previous instructions
concerning placing the handful of pellets in the burnpot and starting your fire (Manually Starting Your
Unit, page 14).
Changing from Pellets to Corn
Your unit was primarily designed to burn pellets, but will also burn corn. Your unit comes ready to
burn pellets by default; if you would like to burn corn in your unit, follow the steps below.
WARNING: Do not open the door on this unit if the Stirrer is still moving!
See instructions “Setting the Stirrer” on page 13 in this manual.
NOTE: Before performing these steps make sure the unit is out and completely cold!!
1. The control board must be reset to burn corn. Unplug the unit and plug back in, then press
the Blower Speed up and down buttons at the same time and release. You should see a “1
through 8” in the Heat Range window. Push the Heat Range up arrow until you see a “5.”
Wait for the window to clear. You are now set to burn corn. To change the stove back to
burn pellets: Push the Heat Range down arrow until you see a “1.” Wait for the window to
clear. You are now set to burn pellets.
2. Follow lighting instructions.
Changing from Pellets to Cherry Pits
Your unit was primarily designed to burn pellets, but will also burn dried cherry pits. Make sure
your supplier is selling Dried Cherry Pits for use as fuel in pellet burning stoves. Do not use cherry
pits designed for crafts or hobbies, as this type is usually bleached or over-dried. Your unit comes
ready to burn pellets by default; if you would like to burn cherry pits in your unit, follow the steps
below.
WARNING: Do not open the door on this unit if the Stirrer is still moving!
See instructions “Setting the Stirrer” on page 13 in this manual.
NOTE: Before performing these steps make sure the unit is out and completely cold!!
1. Remove the Stirrer shaft (See Illustrations 3 & 4 - Page 15). Do not use the Stirrer when
burning cherry pits.
2. The control board must be reset to burn cherry pits. Unplug the unit and plug back in, then
press the Blower Speed up and down buttons at the same time and release. Push the Heat
Range up arrow until you see a “6.” Wait for the window to clear. Remember to remove the
Stirrer (page 15). Set Air On button to “0” (see page 14 – first paragraph). You are now set
to burn cherry pits. To change the stove back to burn corn: Push the Heat Range down
arrow until you see a “5.” Wait for the window to clear. You are now set to burn corn. To
change the stove back to burn pellets: Push the Heat Range down arrow until you see a
“1.” Wait for the window to clear. You are now set to burn pellets. Remember to replace the
stirrer and set it to run when burning pellets and corn (see Setting the Stirrer, page 13).
3. Follow lighting instructions.