Empire Comfort Systems VFSUR24-2 Gas Heater User Manual


 
25741-0-0309 Page 15
Over time, the rockwool will break down and new rockwool will
need to be placed to recreate the original glowing embers effect.
Remove all old rockwool from the appliance and apply new rock
as described in this section or the log manual.
Note: Only the rockwool supplied with this unit or ordered in
accordance with the Parts List on page 20 should be used on
this burner. See the Parts List on page 20 to order replacement
rockwool.


pan. The lava rocks are for decorative effect and are not required

ATTeNTION: DO NOT PLACE LAVA ROCKS ON BURN-
ER, LOGS OR ROCKWOOL. THE LAVA ROCKS SHOULD
ONLY BE PLACED ON THE FIREPLACE FLOOR.
Flames from the pilot (rear right back side of the pan burner) as

is installed.


NOTe:
go up and down.
Glowing embers (rockwool) can cover the pan burner in between
the front and middle logs, but very little is necessary to cover this

orange and stringy. Apply just enough to obtain slow glow and a





During manufacturing, fabricating and shipping, various

bonding agents. These chemicals are not harmful, but may produce
annoying smoke and smells as they are burned off during the initial
operation of the appliance, possibly causing headaches or eye or
lung irritation. This is a normal and temporary occurrence.
The initial break-in operation should last 2-3 hours with the burner
at the highest setting. Provide maximum ventilation by opening
windows or doors to allow odors to dissipate. Any odors remaining
after this initial break-in will be slight and will disappear with
continued use.

Placement of the glowing embers (rockwool) is very individual
and light coverage will provide your best effects. We recommend
separation of the rockwool by hand and make your coverage as

Place just enough rockwool on the burner to obtain the glow and

Do not place rockwool over large ports in rear portion of burner.
Rockwool should not be placed in the area of the pilot assembly.
Application of excess rockwool may adversely affect performance
of the heater.
wArNING: All previously applied rockwool must be removed
prior to reapplication.



Due to the size of the burner, there may be a small delay before
all burner ports ignite.