Empire Comfort Systems PV-28SV55-(C,G)2H(N,P)-1 Indoor Fireplace User Manual


 
24820-1-0409 Page 35
OPERATINGINSTRUCTIONSCHECKLIST
BEFORE OPERATING THIS APPLIANCE, CAREFULLY PROCEED THROUGH THE FOLLOWING
CHECKLIST
1. Read and understand these instructions before installing or
operating this appliance.
2. This appliance is should be installed and repaired by a fully
qualied service person who must be familiar with the instal-
lation of the Mantis Power-Vent High-Efciency Fireplace.
3. Installers who are not familiar with the installation of this ap-
pliance should contact Empire Comfort Systems, Inc. prior to
installing the appliance to avoid creating hazardous operating
conditions.
4. Check and inspect the appliance for gas leaks. In the event
of gas leaks, cut off the gas supply to the heater immediately
and call your gas supplier or installer.
5. Check and verify that all ue venting combustion air intakes
and ue outlets are unobstructed.
6. Refer to pages 19 to 21 for Single Flue pipe and pages 30
to 31 for Co-axial Flue installations. Check that correct ue
pipe and cap has been tted in line with the manufacturer’s
specications as illustrated in this manual pages 11 to 31.
7. Do not use alternative Flue or cap on installation other than
that specied in this manual - otherwise heater will malfunc-
tion and cause hazardous operating conditions and will void
the manufacturer’s warranty.
8. Check and verify that ue pipe connection to the appliance
when using single 1 1/2” ue pipe installation is correctly
installed and secured in line with instruction in this manual,
Pages 19 to 21.
9. Prior to operating the appliance, check for dust or debris on
the burners. Refer to Page 46, Figure 56.
10. Check and verify that logs are place correctly as per instruc-
tions on Page 18 of this manual. If logs are incorrectly po-
sitioned, it can create a hazardous situation, and in most in-
stances, the heater will not operate correctly.
11. Do not light heater without logs installed, as heater will not
operate properly.
12. Check and verify prior to starting the appliance, that all panels
are secured in place and that the main door has been locked in
position.
13. After verifying and checking all the above points, proceed to
lighting instructions. Refer to pages 37 to 38.