Filter
Top Products
Page 2917375-10-0706
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property damage
or personal injury.
Attention: Do not use Figure 48B or Figure 49 to order logs.
Refer to parts view on page 46 and parts list on page 47 and
48 to order logs and/or ember material for your appropriate
fireplace model.
Before you begin: If you are installing logs into the DVP42 or
DVP48 model then this fireplace is supplied with a set of three
ceramic fiber logs. Do not handle these logs with your bare hands.
Always wear gloves to prevent skin irritation from ceramic fibers.
After handling logs, wash your hands gently with soap and water
to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of
this fireplace. Sooting and other problems may result if the logs
are not properly and firmly positioned in the fireplace. Please refer
to Figure 48A, Figure 48B, and Figure 49 and corresponding
WARNING, when completing the following log placement
steps.
1. Remove top louver, grasp louver, lift and pull forward.
2. Lower bottom louver, lift and hinge forward.
3. Release two glass frame spring clamps at bottom of firebox
4. Place bottom log onto main burner. Align holes on bottom log
with (4) locator pins on burner.
5. Place rear log on rear log shelf. Place rear log so that the locator
holes align with the (2) locator tabs in the log support shelf.
6. Place top branch onto flat area of rear log and over the front
of the bottom log.
7. Place decorative rock in front of grates and sides of main
burner.
ATTENTION: Do not place decorative rock on logs or on
burner. The decorative rock should only be placed on the
fireplace floor.
8. After all logs are properly positioned, place small "dime" size
pieces of Rockwool lightly across the front round "blueflame"
ports. Place the ember material (Rockwool pieces) side by side.
Do not stack more than one layer of embers across the burner
ports. See Figure 48A.
9. Replace glass door onto firebox.
10. Secure the two glass frame spring clamps at bottom of
firebox.
11. Align the tabs on top louver brackets with slots in front posts
to secure top louver.
12. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
TOP BRANCH
REAR LOG
BOTTOM
LOG
Figure 48B
Figure 48A
EMBER PLACEMENT
REAR
LOG LOCATOR TABS
BOTTOM LOG LOCATOR PINS
Figure 49
LOG PLACEMENT (3 LOG SET)