Filter
Top Products
Maintenance
6
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
to avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
Accessories
1. Ceiling Fan Controls (see store or catalog).
2. Downrod Extension Kits (see store or catalog).
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
WARNING
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
The use of any other control not specifically
approved for this fan could result in fire, shock and
personal injury.
WARNING
WARNING
16. Pass the end of the safety cable through the two
cable clamps (supplied) (Figure 10). Pass the end
of the safety cable through the eye screw and
then back through the two cable clamps.
CAUTION: It is important to note the proper
installation position of the cable clamps as
illustrated in Figure 10. TO obtain maximum
holding power, install U-bolt section of clip on
dead or short end of cable and saddle on long end
of cable. Improper installation reduces the
efficiency of the connection by as much as 40
percent.
17. After verifying that the cable clamps are
positioned properly on the safety cable, tighten
the nuts on the U-bolts. Leave one or two inches
of slack in the safety cable before tightening the
nuts. Cut off the excess cable.
18. If a remote speed control is to be used, refer to
the Owner’s Manual included with the control for
proper installation and wiring.
19. After completing the installation, restore the
power and test run the fan.
NOTE: When any solid state motor speed control
is used, a humming noise may be present in the
fan on low speed. This hum in no way affects the
operation of the fan and is acceptable in most
industrial installations.
THREADED
STUDS (2)
SAFETY CABLE
#8 LOCKWASHER
KNURLED KNOB
CEILING
COVER
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling cover and the ceiling.
WARNING
EYE SCREW
CABLE CLAMP
TO FAN
Figure 9
Figure 10
U.L. Model No.: HF1160