Filter
Top Products
To fill this humidifier, close the control cover
and remove the bottle cover. To remove the
water bottle, lift the bottle straight up and
out of the cabinet.
The water bottle is designed with an “E-Z-
Fill Side-Cap”. Remove the “E-Z-Fill Side-
Cap” on the side of the water bottle by twist-
ing counterclockwise.
Place the opening of the water bottle under
a water faucet (the bottle should fit under a
four-inch clearance faucet). Fill the water
bottle. Use only clear cold water. Solid
debris could make the valve leak.
Install the fill cap by twisting clockwise.
Hand tighten only.
Check for possible leaks by performing
the following:
1. Grasp bottle handle and hold the bottle
upright over sink.
2. Press up on valve cap plunger for about
one second to let out a little water.
3. Release the plunger.
4. Listen for air bubbles. Look for leaks
around fill cap.
5. If you hear air bubbles or see leaks,
retighten cap and check for leaks again.
NOTE: If either the fill cap or the valve cap
leaks, water may overflow and leak out the
rear vents of the cabinet.
Wipe off excess water from the bottle.
Position the water bottle back into the unit.
Grasp the water bottle handle, and lower
into the cabinet. For proper operation, the
“E-Z-Fill Side-Cap” must be facing the cen-
ter of the cabinet. When positioned proper-
ly, the plunger will open and water will flow
into the cabinet. The water level will auto-
matically remain at approximately 1" until
the bottle is empty. The unit is now ready for
operation.
Water Fill (continued)
6
Valve Cap
Plunger
Turn Counterclockwise
to Remove “E-Z-Fill Side-Cap