Filter
Top Products
13
Troubleshooting
PROBABLE CAUSE
• Speed control in off position.
• Selected humidity level is
obtained.
• No power.
• Float is not free.
• This is normal.
• Air is entering water bottle.
• Dirty filters.
• Bottle cap plunger missing post
in bottom of cabinet.
• Unit is not set up on a level sur-
face. (Float will not sense water
at the rear of the cabinet.)
• Poor water conditions.
• This is an evaporative
humidifier.
TROUBLE
Unit will not run
and Fill Light is not
on.
Unit will not shut
off.
Unit will not dry
out completely.
Bottle continues to
empty.
Unit is not
emptying during
operation.
Bottle not empty-
ing and/or fill
indicator turns on
before bottle is
empty.
Water smells.
No mist appears.
REMEDY
• Turn speed control clockwise.
• Raise humidistat setting if
desired.
• Check 120 volt source for power.
•Free float from obstruction.
•A small amount of water remains
in the cabinet after fill light comes
on.
• Check “E-Z-Fill Side-Cap” and
valve assembly cap to ensure
tightness.
• Check for leak in water bottle.
• Ensure gaskets for “E-Z-Fill Side
Cap” are in place (see repair
parts list).
• Change to fresh new filters.
• Check orientation of bottle.
Reposition so that bottle cap
plunger is depressed by post in
bottom of cabinet.
•Position unit level. (Some carpet
padding may allow unit to set
lower on the left side than the
right side due to the weight of the
water bottle on the left side. Install
coasters under left casters to
level.
• Clean humidifier as instructed in
your Owner’s Manual
• Replace filters and use an EPA
Approved Bacteriostat.
• No mist will appear.
FOR TECHNICAL HELP
If in the USA call 1-800-654-3545
If in Canada call 1-888-744-4687