Filter
Top Products
11
Model No.: CF990
Remote Control Procedures
CODE
SWITCHES
REMOTE CONTROL
BATTERY
COMPARTMENT
COVER
TWO AAA
BATTERIES
REMOTE CONTROL
LEVERS
ON
1
234
5
I
Figure 20
General
Your Emerson Ceiling Fan/Light Remote Control
consists of hand-held transmitter and a receiver which
is mounted under the fan ceiling cover. The remote
control is designed to separately control your ceiling
fan speed and light intensity. There are four push
buttons (
.
,
..
,
...
,
....
) to set the fan speed and turn
the fan off. The light ( ) push button turns the light
on and off and controls the light intensity. The blue
indicator light will illuminate while any button is
pressed, indicating that the battery is good.
The remote control transmitter is powered by two
AAA alkaline batteries (not included). To prevent
possible damage if the batteries should leak, be sure
to remove the batteries when the control is not to be
used for an extended period of time.
Code switches in the transmitter may be set in 32
different positions. If your fan and light go on and off
without using your control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems. To
remedy this situations, simply change the
combination code in your transmitter.
Preset Memory Feature
Your Emerson receiver is equipped with a preset
memory feature. If the AC supply to the receiver is
powered through a wall switch, when the switch is
turned OFF, the control will remember the light
intensity and fan speed. When the switch is turned
back ON the light and fan will resume operation as
they we re prior to the switch being turned OFF.
Installation of Battery
1.Remove the battery cover by pressing firmly below
the arrow and sliding the cover off the control
(Figure 20).
2.Remove the connector from the battery
compartment and install two AAA alkaline batteries.
Setting Operating Frequency of
Transmitter
Your remote control transmitter has code switches
which must be set in one of 32 possible code
combinations. The five levers (numbered 1, 2, 3, 4,
and 5) on the switches are factory-set in the ON (up)
position. Do not use this setting
. Change the switch
settings as follows:
1.Slide the five switch levers in the remote control
(transmitter) to your choice of ON (up) or down
positions. Use a ball-point pen or small screwdriver
and slide the levers firmly up or down.
2.The sixth switch marked ON and I is for dimming
control of lights: Set switch to ON to allow for
dimming of the lights. Set switch to I for no dimming
of the lights such as for fluorescent bulbs.
3. Reinstall the transmitter battery cover.
Programming The Receiver
1.Restore electrical power to the branch circuit at the
circuit breaker or fuse panel.
2.Turn the wall switch "On".
3.Within 1 minute of restoring electricity, push and
hold the "Off" ( ) button for 3-5 seconds to
program the receiver with the transmitter code.
If turned on, the fans lights will blink when the code
is set.
4.Proceed to the next section to learn how to operate
your ceiling fan.