Filter
Top Products
9
How to Wire Your Ceiling Fan
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
1. Disconnect electrical power to the branch circuit at
the circuit breaker or fuse box before attempting to
install the ceiling fan wall control into the outlet box.
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
2. Position the supply wires to the left side of the
outlet box (Figure 15); position the fan wires to the
right side. Partially insert the remote control
receiver (flat side up) until one end rests on the
hanger ball as shown in Figure 15.
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and that
no bare wire is visible at the wire connectors,
except for the ground wire.
3. Refer to Figure 15 and 16 and connect the receiver
wires to the supply wires and the fan motor wires
as follows:
a. Securely connect the green grounding wires from
the hanger ball and the hanger bracket to the
supply grounding conductor (this may be a bare
wire or a wire with green insulation).
b. Securely connect the supply white (neutral) wire to
the receiver white (AC IN N) wire.
c. Securely connect the supply black wire (hot) wire to
the receiver black (AC IN L) wire.
d. Securely connect the fan motor white wire to the
receiver white (TO MOTOR N) wire.
e. Securely connect the fan motor black wire to the
receiver black (TO MOTOR L) wire.
f. Securely connect the fan motor blue wire to the
receiver blue (FOR LIGHT) wire.
g. If installing the optional accessory AL100 accent
light, follow the AL100 installation instructions.
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
GREEN GROUND
WIRE FROM
HANGER BRACKET
RECEIVER
BLACK WIRE
RECEIVER WHITE
WIRE
FAN WHITE WIRE
ANTENNA
A
C
I
N
AC IN L
FOR LIGHT
TO MOTOR N
RECEIVER BLACK
WIRE
RECEIVER WHITE
WIRE
SUPPLY WHITE WIRE
(NEUTRAL)
SUPPLY BLACK
WIRE (HOT)
GROUND WIRE
GREEN GROUND
WIRE FROM
HANGER BALL
FAN BLUE WIRE
1-1/4" THREADED
STUD (2)
TO MOTOR L
FAN BLACK
WIRE
RECEIVER
BLUE WIRE
FAN
YELLOW
WIRE
Figure 15
WARNING
!
STANDARD ON-OFF
WALL SWITCH
BLACK
WHITE
HANGER BALL
GREEN WIRE (GROUND)
FROM HANGER BALL
AND HANGER BRACKET
TWO-CONDUCTOR
CABLE (WITH GROUND)
BLUE
WHITE
BLUE
RED
BLACK
BLACK
WHITE
WHITE
GROUND
WHITE
BLACK (HOT)
TO 120-
VOLT
SUPPLY
YELLOW
Figure 16
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until blades are in place. Noise and fan
damage could result.
WARNING
!
Model No.: CF990