Filter
Top Products
Accessories
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
The use of any other control not specifically
approved for this fan could result in fire, shock and
personal injury.
1. Ceiling Fan/Light Controls (see store or catalog).
2. Downrod Extension Kits (see store or catalog).
WARNING
!
WARNING
!
Maintenance
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
to avoid scratching the finish.
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of an electrical shock.
WARNING
!
12
Model No.: CF990
Using Your Fan
HIGH TO LOW
BUTTONS
POWER INDICATOR
LIGHT
LIGHT BUTTON
FAN BUTTON
STORAGE
BRACKET
TO INSTALL
BRACKET TO WALL:
SLIDE THE COVER
UP TO EXPOSE THE
SCREW HOLES FOR
INSTALLATION
COVER
SCREW
HOLES (2)
WALL
BRACKET
Figure 21
IMPORTANT
Fan installation must be completed, including the
installation of the fan blades, before testing of the
remote control.
Your remote control has full control of your fan and
light (Figure 21).
1.To set the desired fan speed, press one of the four
buttons (
.
,
..
,
...
,
....
) to operate your fan from low to
high speeds.
2.To turn the downlight on, press and release the
( ) button. The light will turn on at the light
intensity previously selected.
3.To vary the intensity of the light, hold the ( )
button down until the desired light intensity is
reached, then release the button.
Note: When turning the light on, light will turn on
at the light intensity previously selected.
4.If airflow is desired in the opposite direction, turn
the fan off and wait for the blades to stop turning.
Then slide the reversing switch, located on top of
the fan motor assembly, to the opposite position
(Figure 19) and turn the fan on again. The blades
will turn in the opposite direction and reverse the
airflow.
Installation of Storage Bracket
A storage bracket is provided for holding your remote
control when not in use (Figure 21). If you desire to
use the bracket. Install it on a wall that is away from
excess heat or humidity.