Filter
Top Products
8
How to Wire Your Ceiling Fan
FAN MOTOR ASSEMBLY
CEILING
MOUNTING PLATE
HOOK
RADIAL SLOT
HOLE
Figure 3
FAN MOTOR ASSEMBLY
SUPPLY
BLACK WIRE
SUPPLY
WHITE WIRE
SUPPLY
GREEN WIRE
FAN MOTOR
BLUE WIRE
FAN MOTOR
BLACK WIRE
FAN MOTOR
WHITE WIRE
Figure 4
1. Temporarily hang the fan motor assembly onto the
ceiling mounting plate hook using the radial slot
nearest the circular hole (Figure 3).
2. Connect the green grounding wires from the fan
motor assembly and the ceiling mounting plate to
the supply green grounding conductor (this may be
a bare wire or wire with green colored insulation).
Securely connect wires with wire connector
(supplied).
NOTE: If you are using an Emerson Light Fixture
with your fan, see the Light Fixture Owner’s
Manual for wiring.
3. Connect the fan motor assembly white wire to the
supply white (neutral) wire using a supplied wire
connector (Figure 4).
4. Securely connect the fan motor black wire to the
supply black (hot) wire using wire connector
supplied.
5. Cap the blue fan wire with a wire connector if using
the supplied wall control. (Figure 4).
6. After connections have been made, turn leads
upward and carefully push leads into the outlet box,
with the white and green leads on one side of the
outlet box and the black and blue leads on the
other side of the outlet box.
To avoid risk of fire or shock, check to see that all
connections are tight, including ground, and that no
bare wire is visible at the wire connectors, except for
the ground wire. Do not operate fan until blades are
in place. Noise and fan damage could result.
WARNING
!
U.L. Model No.: CF905
How to Hang Your Ceiling Fan (continued)
CEILING
AT
LEAST
7'
FLOOR
Figure 1
OUTLET BOX
SCREWS (2)
CEILING
MOUNTING
PLATE HOO
K
CEILING
MOUNTING
PLATE
OUTLET
BOX
Figure 2
1. Disconnect electrical power to the branch circuit at
the circuit breaker or fuse box before attempting to
install the ceiling fan mounting plate on the outlet box.
2. Pull the electrical supply black white, and ground
wires through the center opening of the ceiling
mounting plate before securing the plate to the
outlet box as shown in Figure 2.
3. Position the ceiling mounting plate onto the outlet
box and secure using the two outlet box screws,
supplied with outlet box (Figure 2).
To avoid possible fire or shock, make sure that
electrical wires are not pinched between the ceiling
mounting plate and the fan motor assembly.
WARNING
!