Filter
Top Products
3
This Manual is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Do not install or use fan if any part is
damaged or missing. Call Toll-Free:
1-800-654-3545
!
WARNING
This product is designed to use only
those parts supplied with this product
and/or any accessories designated
specifically for use with this product by
Emerson Electric Co. Substitution of
parts or accessories not designated for
use with this product by Emerson Electric
Co. could result in personal injury or
property damage.
!
WARNING
Tools Needed for Assembly
One Phillips head screwdriver
One 1/4” blade screwdriver
One 7/16” box or open end wrench or
ratchet wrench
One wire stripper
One stepladder
Three wire connectors (supplied)
Materials
Wiring, outlet box and box connectors
must be of type required by the local code.
The minimum wire would be a 3-conductor
(2-wire with ground) of the following sizes:
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
Before assembling your ceiling fan, refer
to section on proper method of wiring
your fan (page 5). If you feel you do not
have enough wiring knowledge or
experience, have your fan installed by a
licensed electrician.
!
WARNING
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each
step is completed, place a check mark in the box. This will insure that all steps
have been completed and will be helpful in finding your place should you be
interrupted.
NOTE: If you are uncertain of part
description, refer to exploded view.
a. Fan housing
b. One mounting plate
c. One motor assembly
d. Five fan blades
e. Five blade flanges with captive
screws
f. One light fitter assembly
g. One lower glass
h. One SW101 Fan/Light Wall Control
(transmitter and receiver)
1. Open styrofoam unit containing fan.
Remove top half of styrofoam unit.
Remove parts and check to see that
you have received the following parts:
1. Sixteen M5 x 6mm washer
head screws
2. Five M5 x 12mm pan head
screws with lockwashers
3. One M6 x 14mm pan head
screw with lockwasher (extra
flange-to-motor hub screw/
lockwasher)
4. Four 1/4-20 hex locknuts
5. Four 1/4” flat washers
6. Three wire connectors
7. One receiver bracket
8. One pull chain pendant
9. One coupling
HI
MED
LOW
FAN OFF
LIGHT
ONOFF
EMERSON
H
G
F
B
C
A
E
D
I
i. One loose pars bag containing:
BP7315 Florissant 3/7/06 8:42 AM Page 3