Filter
Top Products
10. Screw in two 60-watt (maximum)
candelabra bulbs (supplied) in the
light fitter sockets (Figure 14).
11. Remove the finial nut, hex nut and
washer from housing downlight
assembly.
12. Position the glass over the threaded
nipple. Slide the washer onto the
threaded nipple and gently tighten the
hex nut to secure the glass and
washer. Install finial nut finger tight
(Figure 14).
13. Your ceiling fan is now installed and
wired to be controlled by your SW102
Fan/Light Wall Control.
60-WATT (MAX.)
CANDELABRA
BULB (2)
HOUSING
DOWNLIGHT
ASSEMBLY
INSTALL THREE M4 x 8mm
OVAL HEAD SCREWS
GLASS
BOWL
WASHER
HEX NUT
FINIAL NUT
HOUSING
DOWNLIGHT
ASSEMBLY
Figure 14
Make sure there are no wires pinched
between the light fitter and the fitter
adapter plate.
!
WARNING
9. Position the housing downlight
assembly on the light fitter adapter plate
so that the two screws mate with the
keyhole slots in the housing downlight
assembly. Make sure that all wires and
wire connectors are positioned within
the housing downlight assembly. Rotate
the housing downlight assembly
clockwise and tighten the two screws.
Install the other M4 x 8mm oval head
screw in the remaining hole in the
housing downlight assembly.
Operating Your
Ceiling Fan
IMPORTANT
Fan installation must be completed,
including the installation of the fan
blades, before testing of the remote
control.
Your Fan/Light Wall Control (Figure 15)
has full control of your fan and lights.
However, airflow direction is controlled by
a slide switch on the switch housing.
1. Restore electrical power to the outlet
box by turning the electricity on at the
service panel.
2. To set the desired fan speed, press the
HI, MED, or LOW buttons to operate
your fan on high, medium, or low speed
(Figure 15).
3. To turn your fan off, press the OFF
button.
4. To set the level of light brightness,
press and hold the LIGHT button. The
light brightness will continue to
increase then decrease while the
button is held down. When the lights
are at the desired brightness, release
the button.
5. To turn the lights on and off, press and
release the LIGHT button. The lights
will turn on at the light level previously
set (see step 4).
6. If airflow is desired in the opposite
direction, turn the fan off and wait for
the blades to stop turning. Then slide
the reversing switch (on the motor and
upper housing assembly) to the
opposite position (Figure 16) and turn
the fan on again. The blades will turn in
the opposite direction and reverse the
airflow.
11
U.L. Model No.: CF725
BP7369 Vienne 12/7/08 5:21 PM Page 11