Filter
Top Products
Tools Needed for Assembly
One Phillips head screwdriver One stepladder
One 1/4” blade screwdriver One wire stripper
One 5/16” open end wrench, or pliers
Three wire connectors (supplied)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
Unpacking Instructions
For your convenience, check-off boxes are provided next to each step. As each step is com-
pleted, place a check mark in the box. This will insure that all steps have been completed
and will be helpful in finding your place should you be interrupted.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing assembly
c. Five fan blades
d. One ceiling cover
e. Five blade flanges
f. One hanger ball/downrod assembly
g. One hanger bracket
h. One coupling cover
i. One bracket switch housing assembly with
(4) mounting screws and rubber cover
j. One loose parts bag containing:
1.Sixteen M5 x 6 washer head blade screws
2.One M6 x 14 flange screw with
lockwasher
3.One wood pendant
4.One coupling
5.Three wire connectors
6.Two threaded studs
3
7. Two lockwashers
8. Two knurled knobs
9. One clevis pin
10. One hairpin clip
NOTE: Place the parts from the loose parts bag in
a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove the fan motor assembly from the
protective plastic bag. Place the fan assembly into
the upper foam pad with the top of the motor
facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.
HANGER BALL/
DOWNROD ASSEMBLY
BLADE FLANGES
COUPLING
COVER
FAN
BLADES
LOOSE PARTS
BAG
BRACKET SWITCH
HOUSING
ASSEMBLY WITH
RUBBER COVER
CEILING
COVER
SWITCH HOUSING
ASSEMBLY
HANGER
BRACKET
FAN MOTOR
ASSEMBLY
Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 6). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
WARNING
!
WARNING
!
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan
Installed Wire Length Wire Size A.W.G.
Up to 50 ft. 14
50-100 ft. 12
THIS FAN IS SUITABLE FOR WET LOCATIONS
SUCH AS PORCHES, PATIOS, AND DECKS.