Filter
Top Products
8
How to Wire Your Ceiling Fan
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
1. Connect the green grounding lead from the hanger
ball and the green grounding lead from the hanger
bracket to the grounding conductor of supply (this
may be a bare wire or wire with green colored
insulation). Securely connect wires with wire
connectors supplied. (Figure 10.)
Check to see that all connections are tight,
including ground, and that no bare wire is
visible at the wire connectors, except for the
ground wire. Do not operate fan until blades are
in place. Noise and fan damage could result.
WARNING
This product is designed to use only those
parts supplied with this product and/or any
accessories designated specifically for use
with this product by Emerson Electric Co.
Substitution of parts or accessories not
designated for use with this product by
Emerson Electric Co. could result in personal
injury or property damage.
WARNING
U.L. Model No.: CF3300
2. Securely connect the fan motor white wire to the
supply white (neutral) wire using wire connector
supplied (Figure 10). Securely connect the fan
motor black wire to the supply black (hot) wire
using wire connector supplied (Figure 15). The
blue wire is for optional light kit accessory. Do not
connect the blue wire to the supply black wire. Cap
the blue wire with a wire connector supplied. After
connections have been made, turn leads upward
and carefully push leads into the outlet box, with
the white and green leads on one side of the outlet
box and the black and blue leads on the other side
of the outlet box.
To avoid possible electrical shock, be sure
electricity is turned off at the main fuse box
before wiring.
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for
advice, as it must be grounded for safe
operation.
WARNING
SMALL
BARREL
BUSHING
FAN
CABLE
INSTALL LARGE
BRASS BARREL NUT
ONTO THE CABLE
LARGE BRASS
BARREL NUT
FAN CABLE
PASS THE FAN CABLE
THROUGH THE LOOP
AND BACK INTO THE
SMALL BARREL
BUSHING
LOOP THE CABLE
BACK INTO THE
LARGE BARREL
NUT
LARGE BRASS
BARREL NUT
FAN CABLE
Figure 9A
Figure 9B
8. Insert the fan cable through the hole of the large
brass barrel nut (supplied) and push it up the cable
to within one inch of the small brass bushing. Pass
the free end of the cable back through the large
brass barrel nut in the opposite direction and
remove as much slack as possible.
9. Full tighten the 5/32 phillips head screw on the
brass barrel nut to secure the fan cable in position.
Cut off and discard the excess fan cable protruding
from the brass barrel nut (Figure 9B).
SUPPLY
GROUND
WIRE
LISTED
WIRE
CONNECTOR (3)
GREEN WIRE
(GROUND) FROM
HANGER BRACKET
GREEN WIRE
(GROUND) FROM
HANGER BALL
WHITE SUPPLY
(NEUTRAL)
WHITE FAN
WIRE
BLACK SUPPLY (HOT)
BLACK
FAN WIRES
THREADED
STUD (2)
NOTE: CEILING COVER
OMITTED FOR CLARITY.
Figure 10