Filter
Top Products
6
CEILING
CANOPY
DOWNROD
DOWNROD
EXTENSION
HANGER BALL
PIN
SETSCREW
1/4 x 10mm ROUND
HEAD SCREW (4)
Figure 6
10. Route the motor lead wires and support wire
through the downrod extension and the hanger
ball (Figure 6).
11. Securely attach the downrod to the downrod
extension/hanger ball using the four 1/4 x 10mm
round head screws (supplied in the downrod
assembly bag) (Figure 6). The round head screws
must be fully tightened into the downrod
extension. A loose downrod will result with fan
assembly noise and vibration.
12. Be sure the hanger ball setscrews are securely
tighten at this time.
13. The fan comes with blue, black and white leads
that are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above
top of hangerball/downrod assembly. Cut off
excess leads and strip back insulation 1/2-inch
from end of leads.
14. Downrod assembly is now complete.
Electrical Requirements
The fan hanger bracket assembly shall be supported
directly from the supporting building structure. An
electrical box is not acceptable for fan support. The
building structure must be capable of supporting a
load of at least 100 pounds. Consult a qualified
professional to determine if your installation meets the
structural requirements.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
To avoid fire or shock, follow all wiring
instructions carefully.
Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
WARNING
To avoid possible electrical shock, be sure
electricity is turned off at the main fuse box
before wiring.
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for
advise, as it must be grounded for safe
operation.
WARNING
U.L. Model No.: CF3300
How to Hang Your Ceiling Fan
FLOOR
CEILING
AT
LEAST
7'
Figure 7
The fan must be hung with at least 7' of
clearance from floor to blades (Figure 7).
WARNING
Support directly from building structure.
Structure must be capable of reliably
supporting 100 pounds.
WARNING
IMPORTANT
Do not attach fan blades to fan assembly until the
fan assembly is securely installed to the ceiling.
Hanging the fan with blades attached may result
in damage to the fan blades.