Filter
Top Products
6
ETL Model No.: CF110
9. Remove the hanger ball by loosening the setscrew
in the hanger ball until the ball falls freely down the
downrod (Figure 8). Remove the pin from the
downrod, then remove the hanger ball. Retain the
pin and hanger ball for reinstallation in Step 14.
10. Separate, untwist and unkink the two 80” motor
leads. Route the motor lead wires through the
downrod. Align the clevis pin holes in the downrod
with the holes in the motor coupler. Install the clevis
pin and secure with the hairpin clip (Figure 9). The
clevis pin must go through the holes in the motor
coupler and the holes in the downrod. Be sure to
push the straight leg of the hairpin clip through the
hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis
pin. The hairpin clip must be properly installed to
prevent the clevis pin from working loose. Pull on
the downrod to make sure the clevis pin is properly
installed.
11. While pulling up on the downrod, securely tighten
the two setscrews in the motor coupler.
12. Make sure the grommet is properly installed in the
coupler cover, then slide the coupler cover on the
downrod until it rests on the motor housing
(Figure 10).
13. Place the ceiling cover over the downrod. Be sure
that the ceiling cover and the coupler cover are both
oriented correctly (Figure 11).
DOWNROD
PIN
SETSCREW
HANGER BALL
Figure 8
HAIRPIN CLIP
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
MOTOR
COUPLING
HAIRPIN
CLIP
SETSCREW
CLEVIS PIN
JAM NUT
DOWNROD
Figure 9
COUPLER
COVER
DOWNROD
UPPER GLASS
RETAINER
GROMMET
Figure 10
It is critical that the clevis pin in the motor coupler is
properly installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are properly
installed (as shown in Figure 9) could result in the fan
falling.
WARNING
!
COUPLER
COVER
CEILING
COVER
DOWNROD
Figure 11