Filter
Top Products
7
CLEANING THE HOSE AND NOZZLE
The vacuum cleaner stops automatically if the nozzle, tube
or hose becomes blocked, or the filter and dustbag are
blocked. Disconnect from the mains and allow the vacuum
cleaner to cool down for approximately 20-30 minutes.
Clear whatever is causing the blockage and/or replace dirty
filters or the full dustbag. Then restart the vacuum cleaner.
Check the blockage in the hose by dropping a small coin
through it.
Tubes and hose
1 Use a cleaning strip or similiar to clear the tubes and
hose.
2 It is sometimes possible to clear the hose by "massag-
ing" it. However, be careful in case the obstruction has
been caused by glass or needles caught inside the
hose.
Note: The warranty does not cover any damage to hoses
caused by cleaning them.
Cleaning the floor nozzle
3 To avoid reduction in suction power, frequently clean
the dual purpose floor nozzle. The easiest way to clean
it is by using the hose handle.
1
2
3
Z45xx_ifu_2.qxp 2005.04.27. 10:59 Page 7