Electrolux W 345 B/M Carpet Cleaner User Manual


 
SCRUBBING AND DRYING OPERATION
12
SCRUBBING AND DRYING OPERATION
13
When the machine is ready for scrubbing select
the estimated amount of clean liquid required by
pressing the detergent flow control on/off push
button; an indicator will light which can be
increased in three steps for varying the quantity of
liquid delivered to the brushes.
If more liquid is required press the boost pump
on/off push button which will double the amount
of flow; this will be shown by the indicator.
Lower the squeegee to the floor.
Press the suction on/off push button.
Start the brushes rotating, move the machine
slowly forward, then immediately lower the
brushes to the floor by lifting the foot pedal. (If the
brushes are allowed to rotate in contact with the
floor without the machine moving then it is likely
to cause “polo rings” on the floor).
Whilst moving forward observe the cleaning
effect on the floor and adjust the detergent flow to
the minimum required whilst being liquid enough
to be picked up by the squeegee. This allows the
liquid to last longer before having to refill the
tank. If too little liquid is used the floor will dry
with a “sludgy” grey look to it.
The height of the drive handle can be adjusted by
turning the knob
A.
The speed range can be selected by means of
switch B.
Adjust the brush pressure to the minimum
required; this will assist in using the least amount
of power necessary from the battery which will
then last longer before requiring recharge.
B
A
+
Note:
The liquid will be delivered to the brushes only
when the machine is moving forward and the
brushes are rotating. If either the brushes or the
forward traction are stopped the liquid flow
will stop.