Filter
Top Products
SCRUBBING AND DRYING OPERATION
10
SCRUBBING AND DRYING OPERATION
15
Open the tank lid.
Fill the left tank with water to within about 75mm
(3”) from the top edge then add the scrubbing
detergent in a quantity to make a dilution
according to its instruction.
Too strong a mix wastes detergent, too weak a
mix will not work efficiently.
The machine is now ready for use so move off to
the site to be cleaned.
Switch the machine on by turning the key in the
key-switch a quarter turn clockwise.
Unclip the recovery tank emptying hose and
remove the drain plug whilst holding the pipe at
its highest extent, then lower it carefully into a
gully or drain.
Note:
It is against Water Regulations to discharge
detergents into a surface drain, only use a foul
gully or drain.
At the same time as emptying the recovery tank
check if the clean tank requires refilling.
If the clean liquid runs out then it is recommended
that to save time the recovery tank be emptied at
the same time as the clean tank is refilled.
A switch is fitted on the rear panel to the right of
the control handle which controls the drive motor
power. With the switch lever in the up position the
traction motor is disconnected and the machine
may be pushed easily from site to site when the
mains lead is unplugged or when the batteries are
not available.
OFF
ON