Filter
Top Products
7
CLEANING THE HOSE AND NOZZLE
Tubes And Hose
Use a flexible hose or similar item to clear the tube
and the hose. It is sometimes possible to clear the
blockage in the hose by “massaging” it. However, be
careful in case the obstruction has been caused by
glass or needles caught inside the hose.
Note: the warranty does not cover any damage to
hoses caused by cleaning them.
Cleaning The Floor Nozzle
It is recommended to frequently clean the dual
purpose floor nozzle, this will avoid the reduction
of suction and prevents the lever for changing from
hard floors to soft floors being difficult to activate.
The easiest way to clean the nozzle is by connecting
the hose to the vacuum cleaner and use the hose
bent end handle.
The vacuum cleaner does not start
1. Check that the power cord is connected to the
mains power outlet.
2. Check that the plug and power cord are
not damaged.
3. Check for a faulty / blown fuse or that the circuit
breaker has not been switched off.
The vacuum cleaner stops
1. Check whether the dust bag is full, if so empty it.
2. Is the nozzle tube or hose blocked?
3. Are the filters blocked?
Water has entered the vacuum cleaner
It will be necessary for the Fan Unit / Motor to be
checked and if required replaced by an Authorised
Electrolux service centre.
Damage to the Fan Unit / Motor caused by
penetration of water is not covered by warranty.
|
TROUBLE SHOOTING
|
MAINTENANCE
33343 IFU_U3701-U3702_V7.indd 7 19/9/07 10:36:54 AM