Filter
Top Products
6
|
MAINTENANCE
REPLACEMENT OF THE MICRO
EXHAUST FILTER
We recommend that the micro exhaust filter is
inspected at the same of replacing or washing
the motor filter. If it is found to be heavily soiled it
should be replaced.
1. Open the filter grille positioned at the rear of
the Cleaner.
2. Remove the micro exhaust filter from the rear
housing, inspect the condition of the filter. If
heavily soiled replace the filter. Micro exhaust
filter Part No F9000 (Menalux)
3. Place the micro exhaust filter into the rear
housing.
4. Fit the grille into the rear housing ensuring the
locating tabs are located in position and push
the grille for the latch to lock.
The vacuum cleaner stops automatically if the
nozzle, tubes or hose becomes blocked or if the
filters are blocked, this is due to a safety precaution
which prevents the motor from overheating. The
vacuum cleaner is to be switched off by the switch
pedal and at the mains power outlet and the plug
removed from the power outlet, grasping the plug
not the cord for removal.
Allow the vacuum cleaner to cool down for
approximately 30 minutes before
resumption of cleaning.
33343 IFU_U3701-U3702_V7.indd 6 19/9/07 10:36:51 AM