Filter
Top Products
Elation Lighting www.elationlighting.com 13
ZOOM
Calibration of the Zoom
Dimm
Calibration of the Dimmer
SHUT
Calibration of the Shutter
CLRE
Settings in the internal memory (super-user only)
ARES
Adjust Reset
VTIL
Software version Tilt-board
VTRB1
Software version driver board 1
VTRB2
Software version driver board 2
COAD
CODE
xxxx
Use the code for entering the calibration menu (for
authorized persons only)
CYAN
Coarse calibration of the Cyan color wheel
MAGE
Coarse calibration of the Magenta color wheel
YELL
Coarse calibration of the Yellow color wheel
DFSE
Call on the default function values
FEED
Pan/Tilt feedback (error correction) On/Off
EFLG
Correction of faults
3.1 Adjust the DMX- Address (D001)
Right after turning on the POWER
POWER
WASH
WASH
575E
575E
you can see the current DMX-
Address. If there is no DMX- Signal the display flashes.
D001
For the address setting please follow this procedure:
1. Switch On the POWER WASH 575E
POWER WASH 575E
and wait until the fixture reset has
finished ('RESE' is flashing in the display).
2. Press the Mode-key in order to access the main menu. Browse through the
menu by pressing the Up/Down-keys until the display shows D001. Confirm
by pressing the Enter-key (the decimal point is flashing)
3. Use the Up/Down-keys to select the desired address. Confirm the setting by
pressing the Enter-key (the display shows OK) or press the Mode-key to
cancel.
The DMX- Address is stored also while switching off the POWER WASH 575E
POWER WASH 575E
!